Looking for $2000 with coilovers, $1600 without. Just pulled this kit off my Mountaineer and need to find a new home for it. Ryan Jubera designed and TIG welded the lower arms, 1 of the upper arms was originally made by BTF and I modified it to mount on 3/4" heims, added a couple of gussets, and then I built another upper arm to match. Upper and lower arms use 1" uniballs. Kit uses 3" Procomp lift spindle, modified to double-shear the lower uniball and accept a 3/4" bolt. Tapered machined pins from BTF were used for both the upper arm uniball and the outer tie rod heim. Tie rods use 3/4" inner and 7/8" outer heims with a machined clevis by Camburg to attach to the steering rack. I can include 2.5 x 8" Sway-A-Way remote reservoir coilovers with 18" 600# springs. Also have extended braided brake lines, 8" limit straps, all hardware to mount the kit, brake calipers and rotors with good brake pads, and steering rack if desired. I also have a rear lower arm crossmember I'll throw in. Located in Santa Cruz, and I can meet to deliver anywhere between there and Walnut Creek.