kennedy1995
New Member
- Joined
- June 15, 2014
- Messages
- 3
- Reaction score
- 0
- City, State
- victoria bc
- Year, Model & Trim Level
- 1994 Ranger 4.0 4x4
I just finished a full rebuild of my a4ld following glaciers threads on here and now I don't have reverse. :thumbdwn:
The transmission is sound, everything was replaced and everything was in spec. but I have no reverse. The only issue I can think of is that I did not properly spec the Low/Reverse servo I just reused it and put on the new D-ring. With the new D-ring I found that it was hard to compress into the chamber, I think this might cause it to jam and not compress the reverse band.
I also used the reverse band that came with this transmission and the servo that came in a different transmission.
I am going to have a friend tow the truck out then I'll take it for a drive to run it through the gears and see if reverse works after.
Thanks for your help!
The transmission is sound, everything was replaced and everything was in spec. but I have no reverse. The only issue I can think of is that I did not properly spec the Low/Reverse servo I just reused it and put on the new D-ring. With the new D-ring I found that it was hard to compress into the chamber, I think this might cause it to jam and not compress the reverse band.
I also used the reverse band that came with this transmission and the servo that came in a different transmission.
I am going to have a friend tow the truck out then I'll take it for a drive to run it through the gears and see if reverse works after.
Thanks for your help!