shaker1
Well-Known Member
- Joined
- March 6, 2003
- Messages
- 281
- Reaction score
- 1
- City, State
- Algonquin, IL
- Year, Model & Trim Level
- 2006 Explorer XLT 4X4 4.0
2006 4.0L. If I spray a little silicon into where the pulley meets the block it stops making noise for 5 minutes. Noisier when cold.
There is a little plastic bushing between the pulley and the bolt, which is the original piece. I am starting to suspect it is worn and allowing the pulley to "tilt" a tiny bit and contact the "lock" washer between the pulley and the block.
Has anyone run into this before? Solutions? Part name or number of this plastic bushing and/or the lock type washer for this assembly?
There is a little plastic bushing between the pulley and the bolt, which is the original piece. I am starting to suspect it is worn and allowing the pulley to "tilt" a tiny bit and contact the "lock" washer between the pulley and the block.
Has anyone run into this before? Solutions? Part name or number of this plastic bushing and/or the lock type washer for this assembly?