To those with Belltech drop

Can someone with the Belltech springs get a measurement from the center of the rear wheel straight up to the outside edge of the fender? I would like for mine to be lower in the rear and trying to figure out if it would be worth it to get the Belltechs. Thanks.

TTSaleen and jluv have Belltech springs. So you might want to send them a PM for a faster response.

What will you do with your GF springs? And could you measure the front and rear height and post? I want to see how far I'm off from cut springs.

Sorry for the slow response. If I did get the Belltechs (just the rear) and was happy with them, I would try to sell the GF. Probably be a hard sell without the fronts to go with them, though.
Measurements from center of wheel to outer edge of fender trim:
Driver front: 15-13/16"
Passenger front: 15-11/16
Driver rear: 17-7/16"
Passenger rear: 17-11/16"