1354M question

[HeavyFoot]

I've got a 1354 Manual T-case with linkages from a Ranger with the A4LD.. however it's from a first gen with the floor shifter.

Is the manual t-case shifter linkages the same across the years? Would I just need a boot for a 2nd gen Ranger or 1st gen Explorer?

I've had this t-case for 5 years or so when I first considered swapping it into my first gen ranger... case is in good shape at least.

 

[Foxracin]

if its out of a first gen ranger then its a 1350. does it have a fixed yoke output or a slip yoke for front driveshaft?

 

[HeavyFoot]

Fixed all around.. shoot I spaced that

I was hoping...

 

[4x4junkie]

'91-'94 Explorer = '90½-'94 Ranger.

Earlier than that, it's a 1350 (if two fixed yokes, then it's a 1350 from a STX Highrider truck)

 

[snoranger]

The one one the left is a 13-50 STX case. On the right is a 13-54.

Which one do you have?

 

[tweakedlogic]

The one one the left is a 13-50 STX case. On the right is a 13-54.

Which one do you have?

I love the people on this forum. To have both cases on hand, then go to the trouble to move them next to each other and snap a pic for sake of helping a stranger.

 

[snoranger]

I love the people on this forum. To have both cases on hand, then go to the trouble to move them next to each other and snap a pic for sake of helping a stranger.

I cant take credit for taking the pic. All I did was repost the pic.