Search results

Now you tell me. Well we used the old pump (from the original trans that don't have reverse) including the bellhousing and bolt the whole asembly to the reman trans. We just swap it. Again, thank you to all of you.

ITS FIXED! Thank you for all of you specially Glacier991 and Brain. Without you it will never be fixed. Today I checked the presure as suggested by disconnecting one of the cooler line from the radiator and no fluid flow. So for the third time I removed the transmission again and replaced...

Elkhunter, I tried to switch to 4HI and 4LO but doesn't do anything either. I don't know if this matter: I can easily turn the front propeler shaft (between front axle and transfercase) while the engine is off -- which I believe it should because the 4X4 was not engaged. One more...

Well, to make story short, original tranny does not move on reverse only moved on drive gears. So, we removed the no reverse trans and installed a reman bought from advance auto parts store. When I removed the pan of the original no reverse trans there's some small metal shaving in the magnet...

Glacier991 & Brain, Thank you again for your commitment. I followed your suggestions- I moved the truck off the ramp which now sitting in a flat surface. I started it and let it idle for 25 minutes then I shifted to all gears but no trans engagement. One minute while I'm shifting the O/D...

Glacier991, Thank you for your support. I needed it very badly. Talk to you when your phone is not busy. I might invest on the pressure gauge. Brain, Thank you. No, I did not prefill the TC. No I did not run a little while in neutral--probably less than 5 minutes. After we filled...

Thanks to all of you. Well, all the above recomendations were checked except the pressure and everything went okay--no luck. We removed the trans again and reset the TC. We really spent a lot of time to make sure the TC is engaged. When we were satisfied that the TC was engaged, we bolted it...

Wheeww! Thank you Glacier991 and Blee for your unselfish help. We checked fluid level - OK, linkage moved to all gear position, all electrical connector were connected, no leaks. We did not check pressure because we don't have the pressure tool. My plan is to removed the trans again and...

Thank God Glacier991. I'm getting ready to direct this question to you and suddenly you're into it. Well, we changed the whole transmission and we used the old TC. Is there any trick to install the TC? I just pushed the TC into the Trans and bolted the trans to the engine. If there's a...

BUMP! Anybody who can help please. I'm disperate here. What can go wrong during instalation of a reman transmission? New installed transmission does not engage in any gear. I'm stump! Please help.

96 XLT 4.0 V6 4X4. Two days ago I bought a 96 Explorer with bad transmission. My friend and I changed the transmission this weekend with reman but after we done and started the truck, it doesn't move in any gear. The transmission doesn't engage in any gear. We checked all connection and all...