Search results

I jumped the clutch and and confirmed it is spinning.. Attached my gages and tried to add refrigerant. Though I am reading pressure in the system the compressor isn't turning on an pulling refrigerant into the system. I would imagine this means I have a bad compressor. Any ideas? Does...

OK I'll get it and try it early tomorrow morning. Have an appointment with a technician I can't afford tomorrow at 10am. OK I jumped the clutch and the clutch is engaging. I am going to try to charge charge the system. Just bought a R1234 adapter for my manifold gauge set. Since I have...

Thank you. I will try that in the morning. Very helpful.

This is a 3.5l. The relay does not have a pins switch diagram on the side of it.. There are 4 pins. I just tried a few options. Nothing worked. It's #98 in the under the hood fuse panel

You're correct. When I pulled the vacuum and hooked the 1st can up, it took 5 ounces. After that, nothing. I have a simple scan tool but not an advanced tool. Judging by the amount of problems I'm having, that's probably next when I can afford it. What else can I do?

I noticed that the low pressure switch has 3 pins. Which ones do you jump?

I tried to jump the compressor through the AC relay but it did not work. It made a slight clicking sound.

I was noticing that the air was not cooling properly. I decided to add some refrigerant. I have gages and have done this work on my car previously. I bought some cans of refrigerant and tried to charge the system. It would not accept any refrigerant and now the AC has completely stopped...

Thank you to everyone who replied to my message. It turned out it was my key and it cost me over $400 at the dealership to get it fixed. Not surprisingly, and I'm not trying to be a conspiracy theorist here, comma but my car recently did an update and after that my rear camera stopped working...

When I put the key and the lights on the dash come up but there is no crank. I have removed the the starter relay and jumped the 2 terminals.. When I do that the starter immediately engages. It seems to me this must be something having to do with the key. Somebody earlier said that I need to...

I checked with my code scanner. Not getting anything other than a rich intake issue I already had.

I'm having a problem where my car won't start. I have full power and I have changed the starter relay and checked the fuse. I have also jumped the pins under the starter relay and the starter immediately starts. My car will not lock and if I press the key. I've chanced the battery. What else...