Search results

so i have talked to several ford technicians(or ex-ford techs) and most of them say that there is an alignment tool for the digital range transmission sensor. they also told me that this is not needed they stated that i should be able to put the vehicle in park and loosen the nut on the arm...

to be honest i just want everything on the truck working. also an update the #4 fuse must be working becasue when i pulled fuse i could not start the vehicle this morning put it back in and it fired right up.

north east Ohio winter is coming soon.......

sorry about late reply had a kid since the last time i was on. is the problem still there? also a water pump that is not working will not cycle coolant through the system, remember an example i.e. a water pump that starts to go bad may or may not work when engine is reving up but when...

ok so here is what i have done so far. transfer case went out long story: replaced came with a new shift motor on it and it does work tested. disconnect battery to reset all sensors reconnect battery this is a dash system(buttons) 4x4 auto is working 4x4 high is working both tested...

tried in park and nuetral with brake pressed and not pressed.

i have a 2002 ford explorer 227,000+ miles my explorer which has 4x4 auto 4x4 high 4x4 low my 4x4 auto and 4x4 high work just fine, but my 4x4 low blinks 6-9 times, does or did anyone have this problem and if so maybe you can give me a starting area as to what you did to solve your...

you may want to have the water pump checked, thermostats are another good place to look at as well.

not sure on question 1 but question 2 you need to check the front diff fluid level and then you will probably end up needing to replace the fluid, if you put the wrong fluid in it and will shutter and cause problems, the correct fluid type can be found from your local pats store providing...

when it comes to factory alarms they are connected through the door sensors, there is a fuse specifically for the alarm if it is as bad as you say. start with the door jam sensors that tell the car when they are open/closed. there is an ohm reading that you can put an ohm meter on them when...