Search results

Jwrezz - the only programmable module I've seen for fords are only for the f-150, 99 and 00. I know I've seen them in the fordperformanceparts magazine.

Any recommendations on places to get the hypertech ( price wise )? Thanks

Alec I'm looking into getting a chip, but was told that the hypertech only kicks in then the throttle is open all the way, but that superchip improves across the board. With your hypertech chip have you found improvement in general, or only when you floor it? Thanks

Tex, are you sure your not talking about the OBD I systems that were in the 95 and older cars. For those all you need is a volt meter and your set, just count the needle swings. But since the newer OBDII uses letters and numbers, I don't know of anyway to get around using a scanner. But I'm...

Thanks, thats the best price, I've seen yet. Considering its going to run at least 30$ just to get a local place to dump the codes thats not half bad. Too bad JC whitney doesn't offer online sale codes like carparts... oh well. Thanks again.

All the posts I can find refer to the older code scanners. I have a 96 4L 4x4 that I would like to find out why its engine light goes on and stays there, but the cheapest code scanner I can find is 250$ Which cuts into the superchip fund. I was just wondering if anyone knew of any other...

Thats what I thought about only using super unleaded with the superchip. But today, I asked the rep. from Superchip I think his name is mike ( he posts on f150online ) and he said that 1/2 the chips if you try to run less than 92 octane will ping, the other 1/2 will automatically self adust the...

Rick thanks for the information, I will be looking much more seriously before going ahead. I'll check into maybe getting a stock fan instead of an aftermarket job. Just out of curiousity, I noticed in the other thread, you said you had the cat back exhaust and had other modifications to...

Just curious if anyone had heard anything about replacing the Fan with an electric fan, tring to up the HP? Thanks '96 4x4, v6 [This message has been edited by island (edited 04-28-2000).]