Search results

Well I took the connector off and checked it. All the pins were there that were supposed to be. I didnt see anything wrong with it. So I cleaned it off and reconnected it, making sure it was in there good. Then stated it up and it acted like it did before, it isnt slipping anymore but still...

I read somewhere else that I can check the continuity of the wires from the pcm connector to fuse 37 but I think I might be doing it wrong because all of them are open if you could send that pin out that would be awesome

I bought a code reader and cleared the codes now I only get P0743 P0755 and P0760. All my tools are at my friends house and hes gone for the day so I am unable to get to the plug to check it out. I will as soon as I can.

Ok ill try that. Thank you again

I checked the fuse and it was good. I actually put the old block back in cause I ordered a new one to replace the one i just got. I figured it was better to have some hard shifting every once in a while as opposed to slipping at low speeds. But now the old block is slipping too. I checked...

I checked and the plug is in there pretty good. I also checked any fuses that were transmission related and they were all good too.

I'm pretty sure it is. The bolt went in. I would have to check in the morning.

No its doesnt smell burnt, it was a little dark but not black. It didnt start slipping until after i replaced the solenoid pack.

Hello, I've got an '02 Explorer with some transmission problems. A couple weeks ago the O/D light started blinking and when I had the codes read it came back with P0796. Everything I read about that indicated the solenoid pack needed to be replaced. I ordered one and installed it but my...