4

i was shopping on amazon for a new pump for a 4.0 but most of the ones for sale are the press-on pulley types and mine is the one that's held on by 3 10mm bolts to the triangle-shaped center axle why are there 2 different types for the 4.0? they all say compatible - or am I supposed to press...

2008 explorer 4.0 so far ive replaced alternator, tensioner, idler, belt, ac compressor ive examined every pulley 5x for play etc....the only one that has any is the PS pump pulley moves in/out a few mm....is that normal? the squeal is loud like the belt is too loose but im using the spec...

Selling my Velgen VF9 22×10.5 +30 offset in gloss black. 4 wheels and tires in very good condition. These awesome wheels were on my 22 Ford Explorer ST. I recently traded in my ST and was able to swap originals back on. Unfortunately, the dealership scratched a few of the wheels by simply...

I had a head gasket failure due to overheating. Took care of the overheating problem. Warped heads. Got the heads resurfaced, valves lapped, new seals gaskets etc. I bought the camshaft alignment kit, and tried the passenger side first, but quickly discovered there is an issue. There is a gap...

i was wondering if anyone had drilled and tapped the back sides of the lower intake manifold. i was curious about adding a coolant crossover since the rear passages always seem to have more gunk or just blocked up.

OK so while replacing the Exhaust manifolds I managed to break some studs so decided to pull the Motor out for easier extraction and found a broken mount so definitely a good thing to find now. But now the question is do I replace the chains etc. While it's out even though I've never had any...

I recently, 3 days ago, began having the death rattle, but only during WARM starts! Not COLD starts! I am disabled & no longer have tools, so I rely on a mechanic. I recently had him install an aluminum thermo housing & new Ford Motor Company-brand external tensioners. It has run fine for 3 or 4...

So I recently had a pretty bad timing failure, I was driving one night and from about 60-80km/h I lost the ability to accelerate, foot to the floor and the RPMs did not rise what so ever, I let go off the gas pedal and the engine was just maintaining speed, didn't even slow down. After about 5...

Hello Forum-- I just picked up a 2006 Explorer Limited 4.6 RWD. It has 210,000 miles on it and has been very well maintained. The engine seems to run beautifully, but it does have a light tick to it. I think we can rule out exhaust manifold leak. How can we tell the difference between a roller...

The guys were spotting to help John get over the rocks....he had no problems

The Guys got out of their trucks and were looking up the trail to see if we could get over the rocks that were there

John, Saera and I bring up the rear

Here is Aaron sending water flying while going through the water pit

John DeRocha following Aaron up the trail

Aaron was the first to go up the trail, as you can see by the sign near the tree, we were on a public trail

I snapped this photo in the parking lot of Monro where Isaac had taken his Explorer for an alignment. This is across from the Champlain Valley Exposition center in Essex Junction, Vermont

This photo was taken at a different angle

A photo of the trucks belonging to our club at the hotel in South Burlington, Vermont where we stayed

Aaron was told by someone about some wheeling places in Vermont, not far from the Jamboree, we decided to forgo the Jamboree the first day and go wheeling instead

Tire carrier on previous owner's truck. Stock or near stock tire.

My wife sitting in her XLT on a road trip to Mt Alyeska