obd

2000 Eddie Bauer 2 WD 4.0 SOHC .... the check engine light just came on and when attempting to scan for codes, I have no power at the OBD port. the fuse diagram really doesnt say... can someone comment?

I have just recently heard about proformance chips that after about 200 miles can tune your car to give more HP and save gas, are these worth it? Please give more info

I have an 2003 Explorer with the 4.6l. The check engine light came on and I'm having issues reading the codes. Code reader powers on, but gets stuck at reading the J1850 PWM protocol. If wait long enough it will go to J1850 PWM protocol failed. I have an Konnwei KW808 OBD II/EOBD. This code...

Hi I switched my 2004 XLT Explorer's instrument cluster into diagnostic mode to monitor my coolant temp on a long hill climb towing my boat. Scrolling round the options, I spotted that the DTC section was showing an error E013 which remained after a stop/start cycle. At home I plugged in my...

The car: 2005 2WD 4.0 automatic with about 110K miles on it. The symptoms: Check Engine light comes back on within 20-40 miles of being reset P0193 code (fuel pressure sensor high) Poor gas millage, around 12 MPG (was about 18 MPG a year ago) Occasionally runs slightly rough, mainly at idle We...

No power to obd input jump wired power from lighter circuit. was able to talk to onboard computer to try to reprogram anti theft sym.with 2ea new chipped ignition keys from a botched theft attempt had to replace ignition and steering column while entering anti-theft sym.onboard computer would...

Has anybody found one that works on a 02-05 Explorer. I've tried 3 different ELM327 clones and none of them works, although they all work fine on my 09 Volvo. My vintage Harbor Freight scanner works so I don't think I have a bad OBD port issue.

Went to get my 2000 Explorer Limited inspected in NC. Their computer would not talk to the car through the OBD connect (just under steering wheel). The fix was super easy, but non-intuitive. The cigarette lighter fuse (no. 17) was blown and this apparently sends power to that connector...

Hi, I want to give a solution I found for the error P0351: SYMPTOMS: I had no spark from the coil to the spark plug in the cylinders #1 and #5. PLEASE VERIFY THE NUMBER OF THE CYLINDERS. With the engine running check for the spark. The coil connector has 4 yellow wires. For the cylinder 1...

Service Engine? What do these codes mean? - FIXED! My Service Engine Light just came on out of nowhere. Ran a scanner and I've got two codes... C1342 - General Module / Timing Control Module Defective P0174 - Bank 2 System too Lean 2003 Explorer Eddie Bauer 4WD What is going on? I...

Hello!!! I'm trying to build a carputer with "trip computer" for my Explorer. There are a lot of softwares to show fuel consumption reading OBDII codes but, unfortunatly, my Explorer (1994) has only OBD I and I cannot find nothing :roll::roll::roll: ..... Please help me....