out | Ford Explorer Forums

  • Register Today It's free!

out

  1. A

    can't figure out serpentine squeal - 4.0

    2008 explorer 4.0 so far ive replaced alternator, tensioner, idler, belt, ac compressor ive examined every pulley 5x for play etc....the only one that has any is the PS pump pulley moves in/out a few mm....is that normal? the squeal is loud like the belt is too loose but im using the spec...
  2. K

    What should i take?

    I found a part out on a 2013 explorer limited, with the third row seats. im planning in taking the door panels and overall swap the interior with the seats. Are there any other things i should take? I have a 2014 piu.
  3. A

    2019 3.5 ecotec, out of nowhere = dead

    I have a 2019 Explorer 3.5 turbo awd Police Utility this morning it was dead. The dome light barely lights up, the guages light up, but no info center, the radio will say Ford when you turn it on, but then that turns off. No HVAC power, Wont turn over power locks and windows dont work. So I...
  4. Taillights with & without a cut out.

    Taillights with & without a cut out.

    The light on the left is for a non rear wiper equipped Aerostar. The light on the right is for a rear wiper equipped Aerostar.
  5. Drill a hole then pry it out.

    Drill a hole then pry it out.

  6. Break out diagram of a Ford alternator.

    Break out diagram of a Ford alternator.

  7. The tube is refilled after it's cleaned out.

    The tube is refilled after it's cleaned out.

  8. Compressed air pushed out the bottom.

    Compressed air pushed out the bottom.

  9. Break out view of the banana plugs.

    Break out view of the banana plugs.

  10. The wheel studs are hammered out.

    The wheel studs are hammered out.

  11. A4LD valve body break out view (2 solenoids).

    A4LD valve body break out view (2 solenoids).

  12. Universal 4 wire oxygen sensor pin out.

    Universal 4 wire oxygen sensor pin out.

  13. Air Charge Temperature Sensor Pin Out.

    Air Charge Temperature Sensor Pin Out.

  14. The tape is smoothed out.

    The tape is smoothed out.

  15. A Rotozip is cutting the top out.

    A Rotozip is cutting the top out.

  16. Drawing ink out of the bottle.

    Drawing ink out of the bottle.

  17. The caliper pin tool is pushing out the bolt.

    The caliper pin tool is pushing out the bolt.

  18. The caliper is coming out.

    The caliper is coming out.

  19. Break out diagram of a turbo charger.

    Break out diagram of a turbo charger.

  20. Horn & relay wiring schematic.

    Horn & relay wiring schematic.

  21. 86 - 91 Aerostar alternator break out schematic diagram.

    86 - 91 Aerostar alternator break out schematic diagram.

    (1) Alternator. (2) Voltage regulator. (3) Front bearing. (4) Rear bearing. (5) Stator. (6) Rotor. (7) Brushes. (8) Rectifier.
  22. Break out view of the pin and nail puller.

    Break out view of the pin and nail puller.

    This slap hammer has a keyless chuck as a removable attachment. It could be used for pulling out nails from mouldings without leaving pry marks on the wood. Another use is for removing that subborn dowel pin on the bottom of a Ford transmission.
  23. Torque converter break out diagram.

    Torque converter break out diagram.

    This is an internal diagram of a torque converter.
  24. Raush Creek Pine Grove PA

    Raush Creek Pine Grove PA

  25. Out in IFalls for 21st

    Out in IFalls for 21st

    Having fun on my 21st, 1st stop only...
  26. Andy and Me

    Andy and Me

    Hanging out again
  27. Scholke and Me

    Scholke and Me

    Hanging out at the bar with friends!
  28. Marcs Towed

    Marcs Towed

    My friends pouting right now... he shoulda rolled down his window.
  29. BFG ATKos black-out

    BFG ATKos black-out

  30. BFG ATKos white-out

    BFG ATKos white-out

  31. gettin pulled out

    gettin pulled out

    the yota pullin me out, the front tire is 2' off the ground.
Back
Top