08EddieAuto
New Member
- Joined
- May 18, 2016
- Messages
- 1
- Reaction score
- 0
- City, State
- Nampa, ID
- Year, Model & Trim Level
- 2008 Ford Explorer
Hey everyone!
My name is John and I have been poking around for awhile trying to find a answer to this issue and have so been unsuccessful. I have a 2008 Explorer Eddie Bauer edition with the 4.6. My passenger front turn signal will not illuminate when turned on. I have replaced the bulb and socket for the bulb that goes into the headlight assembly. I have also replaced the multi switch on the steering column and checked the wires leading to the switch for frays or pinched wires and all look good. Using a test light it does not appear that I am getting power to the socket, i.e. the bulb. I am wondering if anyone has any ideas on where I could look from here? I was thinking maybe signal relay or fuse, but I would think both of the passenger side lights wouldn't work if that was the case? it does give me the "check RF bulb" error on the dash display when using the signal after start up. The light also is non-functional when using the hazards. Any help would be awesome! Thanks in advance for all advice and hopefully I can get this stupid thing to work again.
My name is John and I have been poking around for awhile trying to find a answer to this issue and have so been unsuccessful. I have a 2008 Explorer Eddie Bauer edition with the 4.6. My passenger front turn signal will not illuminate when turned on. I have replaced the bulb and socket for the bulb that goes into the headlight assembly. I have also replaced the multi switch on the steering column and checked the wires leading to the switch for frays or pinched wires and all look good. Using a test light it does not appear that I am getting power to the socket, i.e. the bulb. I am wondering if anyone has any ideas on where I could look from here? I was thinking maybe signal relay or fuse, but I would think both of the passenger side lights wouldn't work if that was the case? it does give me the "check RF bulb" error on the dash display when using the signal after start up. The light also is non-functional when using the hazards. Any help would be awesome! Thanks in advance for all advice and hopefully I can get this stupid thing to work again.
