nismotunedgtr
Well-Known Member
- Joined
- September 11, 2004
- Messages
- 165
- Reaction score
- 0
- City, State
- Windham, Maine
- Year, Model & Trim Level
- '93 XLT 250k miles
So my girl just bought a really nice black /gray fully loaded 97 Limited up here in Maine. Paid $900 and drove it home to Portland from Bangor.
So far I've done:
-Plugs and wires (had 3 different types of plugs and wires)
-Jmod done to the tranny (12k miles on reman, shifts amazing!)
-All fluids changed to Synthetic (EXCEPT T case)
-Air ride removed completely
-New rear calipers, rotors and ceramic pads all around
-$1200 Alpine component sounds sytem
-MAC cat back
-All interior LED lighting
-Rear shackles
-Front poly sway bar bushings and links
-Upper control arm bushings
-Lowered 2" and aligned
When we bought it the owner said it had no front driveshaft because the driveshaft was bad. Not unheard of obviously...
Well, it doesn't roll away in park. It slowly creeps, like maybe 6" over 16 hour period.
The front diff pinion flops all around and leaks BAD.
So right now it needs a front diff rebuild and a driveshaft.
I am concerned it also needs a transfer case, because it doesn't roll away without the front driveshaft. I fear the fluid coupling is worn and not slipping like it should.
Any input?
So far I've done:
-Plugs and wires (had 3 different types of plugs and wires)
-Jmod done to the tranny (12k miles on reman, shifts amazing!)
-All fluids changed to Synthetic (EXCEPT T case)
-Air ride removed completely
-New rear calipers, rotors and ceramic pads all around
-$1200 Alpine component sounds sytem
-MAC cat back
-All interior LED lighting
-Rear shackles
-Front poly sway bar bushings and links
-Upper control arm bushings
-Lowered 2" and aligned
When we bought it the owner said it had no front driveshaft because the driveshaft was bad. Not unheard of obviously...
Well, it doesn't roll away in park. It slowly creeps, like maybe 6" over 16 hour period.
The front diff pinion flops all around and leaks BAD.
So right now it needs a front diff rebuild and a driveshaft.
I am concerned it also needs a transfer case, because it doesn't roll away without the front driveshaft. I fear the fluid coupling is worn and not slipping like it should.
Any input?