Beginner engine mods finished

[Bashman]

Installed the 66mm BBK throttle body, 70mm MAS and KKM true-rev yesterday. Total time was 1.5 hrs. The hardest part was getting the stock intake tube over the much larger MAS. It took a bit of wrastlin' and various tongue positions coupled with the right choice of words but finally I got it installed properly. The truck sounds great now, not much louder than stock but has a nice deep tone to it. Throttle response has also improved greatly. I recommend these mods to any gen 1X. Next weekend I hope to get the Apten chip installed to complete the project.

 

[Redrig]

good deal. i have a question for ya your true rev is it a s&b filter? i ordered one and it says nothing about true rev on it. thanks

 

[Ryan1]

What were the total expenses??

Ryan

 

[TAS98xlt]

Where'd you get your 80mm MAS at? I'm lookin for one.

Ted

 

[Bashman]

redig:
Yes it is a S&B filter.

Ryan:
Total expenses were $507.57 u.s. (mas and tb), $89.95 u.s. (KKM) and $375.00 can. (Magnaflow, installed).

TAS98xlt:
Sorry, that was a typo, should have read 70 mm, it's fixed now. I purchased both the TB and MAS through Explorer Express. I know some places sell them for a little less but these guys advertise on the site.