Passenger window & possible ball joint issue.

[silversnake3103]

Hey guys so I'm not new to forums but I'm new to the Explorer forum. I own an 02' xlt 4x4 and as I put my passenger window down today it wouldn't go back up. I read a few other forums checked fuses and power to the switch. Everything is good there. I even swapped switches with one of the rear windows and the switch worked fine. The only thing I notice is that when I use either the master or the pass. switch and I push the down arrow the green light that comes through the switch stays on, but when I push up, the pass. switch light goes out. Is it some sort of wiring problem or a bad motor? For my second issue as of about a week ago, whenever I drive at any speed, there is a small vibration that I can not only hear but feel on the floorboard and on up to the steering wheel. The catch is that it only happens when I turn the car to the right, not the left. I have no idea with this one could be. Maybe upper and lower ball joints? Any and all help with either of these issues would be greatly appreciated.

 

[Limited02]

As far as the switches, I'd look into the door wiring to make sure nothing is getting kinked. Seems to be a common problem. But it could be anything

As far as feeling a vibration when you turn, I would bet it's your front wheel bearing. Give it some time and if you start noticeing a rum rum rum noise that gets slower as you come to a stop(wheels striaght), then your bearings are toast. If that ends up being the case, make sure you replace both at once because the other isn't far behind.