Pinion yoke from Jeep work on TTB D35?

[WickedWindsor]

I need a new yoke for my D35 TTB Dif.
I'm looking at ones for Jeeps that convert to a U-Bolt design.
Can I use one that is designed for a Jeep D35 Rear? I figured since I had to get a new one, I may as well upgrade it.
I also wonder if a D30 from a Jeep front axle would work? I can't find any info anywhere.

 

[Creager]

I'm not exactly sure, although i took the liberty to compare some part numbers and it doesnt look too good...

Dana 35 TTB Yoke : PINION YOKE - 26 SPLINE - DANA 35 IFS - 1310 SERIES - 2-4-6901-1X

Dana 35 Rear (jeep): PINION YOKE - 26 SPLINE - DANA 35 - 2-4-4601-1

Dana 30 front (jeep): 26 SPLINE - DANA 30 - 2-4-3581X

I'm guessing that technically, it will fit your pinoin. Although you would need a special u-joint to adapt that yoke to your driveshaft.

 

[WickedWindsor]

Thanks Creager, I guess I'll stick to going to the Dealer for a stock replacement.
I was thinking of drilling out the holes in it and find some U-bolts that would fit. But of course, as luck would have it, my "easy out" broke off inside. I can't drill IT out.