T3hN1cksta
Member
- Joined
- February 5, 2011
- Messages
- 15
- Reaction score
- 0
- City, State
- Las Vegas, Nevada
- Year, Model & Trim Level
- 1994 Explorer Xlt 4x4
Ok, three weeks ago i replaced my modulator because the old one was leaking, ive done everything, cleaned and replaced vacuum lines, taken the modulator out 3 times, made sure pin wasnt bent or missing, taken the car to aamco (they were as clueless as i was, they asked if i re-installed the pin in the modulator, i did), tryed adjusting the modulator and its still doing the exact same thing!! It still shifts from 1-2 then downshifts back into 1st then back into 2nd, 3rd & 4th are delayed and require you to release the gas in order to shift.
Im getting to my whits end with it, who knew a little $20 part could cause such frustration? Ive done everything everyone's suggested, but it still continues
Is there anything else that could be causing this? Because the car ran flawlessly before we replaced the old modulator. sorry about the little bit of ranting, it gets a little frustrating after a while lol. Its getting to the point where the cars going to have to go to ford if i cant figure this out, any tips??
Im getting to my whits end with it, who knew a little $20 part could cause such frustration? Ive done everything everyone's suggested, but it still continues
Is there anything else that could be causing this? Because the car ran flawlessly before we replaced the old modulator. sorry about the little bit of ranting, it gets a little frustrating after a while lol. Its getting to the point where the cars going to have to go to ford if i cant figure this out, any tips??
