Throw out bearing replacement on a 1988 Ranger.

[1988dangerranger]

i got a 1988 ranger w/ a freshly rebuilt trans but who owned the truck befor me replaced the clutch but not the TO bearing!! i need to no how to pull the old one off the shaft and slide the new one on. THX

 

[Sams01XplrSprt]

welcome danger

 

[BrooklynBay]

Welcome to this forum! I've moved your thread to the Ranger section for you.

 

[1988dangerranger]

Welcome to this forum! I've moved your thread to the Ranger section for you.

oh thanks! not yet sure what to do and where to go to post

 

[FordRanger91]

Hello all Ford fans, I hail from the mountainous valley of the Kootenays in the south eastern corner of British Columbia, Canada. I love FORDS and own a 1978 full size Bronco xlt ranger. 1990 f150 s/c shortbox 4x4 p/u, 1991 ranger xlt,1989 s/c 4x4 p/u and just bought my son a 1993 Bronco XLT 4x4. Look forward to asking and replying to questions on our trucks. Fords Forever-FordRanger91

 

[blue88b2]

i got a 1988 ranger w/ a freshly rebuilt trans but who owned the truck befor me replaced the clutch but not the TO bearing!! i need to no how to pull the old one off the shaft and slide the new one on. THX

if you haven't done it, i'd recomend you replace the whole slave assy. it should come with a throwout bearing. I did a new clutch and tranny swap on my old ranger a few years back, and about 2000 miles of driving it the slave went bad. I think they're like $130 but it's worth every penny not to do the job twice. that should also give you an idea of how it all goes together. Gluck