iamdestruktor
Member
- Joined
- May 3, 2013
- Messages
- 31
- Reaction score
- 0
- City, State
- QUEENS, NY
- Year, Model & Trim Level
- 2004 Explorer XLS Limited
So I've been having these two issues. When I flick the knob to turn either right or left, the light will blink to the corresponding turn just once and then stop. The knob will stay in place until the turn is complete. When I flick the knob back for high beam, it doesn't stay in the position nor even light up. Same for when I pull the knob.
So then I bought a replacement multifunction switch on ebay, and installed it. I encounter the same issue. Oh, and the hazard light worked fine with both switches. Any ideas? I hope it's not a wiring problem, when I replaced the part I didn't notice anything odd, but then again my focus was in installing the new part properly.
So then I bought a replacement multifunction switch on ebay, and installed it. I encounter the same issue. Oh, and the hazard light worked fine with both switches. Any ideas? I hope it's not a wiring problem, when I replaced the part I didn't notice anything odd, but then again my focus was in installing the new part properly.
