Search results

I am interested I. The rack and pinion

I am very interested. Limited slip?

I got a rebuilt torque converter, wrecking yard said; replace front pump seal. I am going to add a drain plug to pan so I can fully change out fluid. Should I use synthetic transmission fluid?

Hi, I have a similar problems. I am picking up a 4r44e out of an aerostar 1996 and it been stored 10 years. Ford reman stickers are on it. It's $400. What kind of prep will it need?

Josh, having new problem, can't get site to post new thread. Friend smell fuel in exhaust and there are no codes.

Well the work was done in February. So, lol it is. I have poor gas milage at times. No codes. Changed fuel filter. Have good power no stalls, quick starting. I have a brand new boss upper plenum with the sensors, new OEM Ford, slap onnnew egr, and see what happens, any advice?

All fixed. Wires, plug, coil pack, maf sensor.

Found donor vehicle for RWD to AWD swap. My Aerostar is a 1996 RWD. Will the 1990 K frame bolt to my 3.0 Aerostar? Both Aerostar's are short vans. This will be 1990 parts over to a 1996. I will keep my 3.0 V6. I will be lacking a transmission and will get a TCI AWD tranny. Any word on...

I will post s picture if it's ok.

Need to fix Rust on driver side firewall bulkhead. Any suggestions?

How much and where are you located?

I ordered the wiring diagram factory book for 2997 on eBay. O will also get s factory diagram from 1996, and have a friend look at it.

Y Yes

Would that require a module?

Want to adapt 1996 rear tail wiring to 1997 Aerostar tail light assy. Is it possible?

Having problem with rest tail light assy 2997 aerostar

Where can you get weatherstrip for rear tail gate?

Where can I get a rear wiper/washrr switch for my 2996 Ford Aerostar?

Having trouble unlocking door from inside via door handle and when unlocking with key outside.

I will do that tomorrow. Thanks.

Took it back to shop. No charge for labor, owner said diagnostic smoke test should have been done. PCV dirty and loose. Replace for $20, no labor charged. Advised mass air flow meter needs testing, I will replace it myself. Is there any special method? Look straight forward. mark

Mechanic read code, observed evap cannisterhose to intake, replaced, code returned after two cycles. Van starts every time, does not stall, sluggish in the mountains. Help.

Can't find your vans pictures. Would like to see them. Thanks.

So I can keep the the 3.0 but drop it out to bolt to the set sub frame of the 1993 extended sub frame?

My van is the shorter one 2 wheel drive 96, can I use my transmission?