94 ford explorer bagged

[WaTTz305]

Ok i basically got the rear done. Now im stuck in the front. Ive been researchin but havent got a straight foward answer. So what is it that i need to get it done? And get it real low? Thanks in advanced guys

 

[WaTTz305]

Help meh help meeeh

 

[FIND]

Is it 2wd or 4wd. If it is 4wd, you will never get it lower than a 2 inch drop. If it is 2wd, you drop it like you do any other minitruck. It will go 3" on the back (probably) without frame notching.... But it will ride rough.... And the front you should get some drop springs and beams. If you are using bags, they probably won't get you down that 3 inches on their own. If you want to put it as far down as you can, look for spdrcer34's how-to on frame notching, measure for bags and get some drop beams.

 

[WaTTz305]

Is it 2wd or 4wd. If it is 4wd, you will never get it lower than a 2 inch drop. If it is 2wd, you drop it like you do any other minitruck.

Yep its a 2wd. Is there any sort of modifications i would have to do to the ibeams?

 

[WaTTz305]

Im not looking to have the front on the ground since i am on 22's but i want it to be low as hell, like i want the lil lip on the front bumper to be about 2 to 3 inches away from the ground. And i really dot care about camber issues since its gonna be bagged after all

 

[FIND]

Really, it depends on how low you are going to drop it, and what you want ride height to be. If you want to go lower than a couple inches drop, you are going to need drop I-beams. Maybe you could talk to Brandon@BTF-fab. He is a member here that does cut and turn beams for raising trucks. Maybe he can do drop beams as well.

Or you could just search the site..... since you are asking questions that have been thoroughly answered before on this site by people who know a lot more than me about dropping trucks.

 

[WaTTz305]

Really, it depends on how low you are going to drop it, and what you want ride height to be. If you want to go lower than a couple inches drop, you are going to need drop I-beams. Maybe you could talk to Brandon@BTF-fab. He is a member here that does cut and turn beams for raising trucks. Maybe he can do drop beams as well.

Or you could just search the site..... since you are asking questions that have been thoroughly answered before on this site by people who know a lot more than me about dropping trucks.

Gotcha. Well im wantig the front lip on my bumper to be about 2 to 3 inches off the ground. And the ride height either factory like now or a bit lower.
Also were could i purchase the ibeams?

 

[Jason94sport]

Did you check out this section....
http://www.explorerforum.com/forums/forumdisplay.php?f=46

And message Ricky1213, he had a bagged 1st gen he sold not too long ago & he's in west palm.