Search results

Look at the bright side, at least you wouln't have to worry about wearing out the hinges and latch on that door.

I've had really good luck over the past 40 or so years with Marvel Mystery Oil. Add one quart in place of 1 quart of oil. It doesn't work over night but it will eventually clean up things in the engine and usually stop lifter noise. Try it you will like it!

I have the same problem with my 92. I replaced the sending unit but it didn't cure the problem. I did notice that when it was showing a very low temp that I could move the connector on the sending unit ant it would jump up. I do believe it is the angled wire connector that attaches to the...

I call mine Teddy Roosevelt, Not because I am a big follower of the late great president but because it is a rough riding SOB.

Don't use JB Weld on anything that gets hot. It melts and makes a real mess. Been there done that, don't work !!!!!

Shouldn't be that big a deal but I would also replace the rear engine seal while you are at it.

Sounds like it could be the vaccum modulator on the transmission. You can check it by pulling the rubber line off at the modulater and if there is transmission fluid there that is most likely your proble. I just went through the same problem.

No I was not suggesting that the exhaust system can be remove from the top. I also replaced my o2 sensor while I was at it. It is a real task to reach the plug, especually when pluging the new one in. You may also want ot get a new cat gasket befor you start. Good idea to replace it. I wish you...

The factory one with the rubber plug did not work. I think they got one from NAPA and used it. How it is adjusted I do not know. I think it is turned in until it makes contact with the little pin that is installed inside the Modulator. Be carful not to loose the little pin. When you remove the...

I just installed the Gibson cat back system on my 92 Explorer and so far am very happy with it. I like the nice mellow sound and the ease of installation. Not sure if any increase in MPG but did notice a slight increase in get up and go. Hope this helps. I got mine from truckperformance.com...

Just went through the replacing of the modulater bit. It is a real SOB to get at. The cat has to be removed and it is still difficult. I got the new modulator from Ford, installed it and it still didn't shift right from 2nd to 3rd. Ended up taking it into a local dealed. the checked it out...

Try www.truckperformance.com . They have high flow cats and also advise as to what gains you can expect.

Try www.truckperformance.com. I just got a Gibson cat back from them. Good price and easy install. Be sure to have a new set of bolts and springs befor you start.

Try www.truckperformance.com I seen them there. I just got their Gibson cat back and am very happy with it.

Just for your information, you might check out truckperformance.com. They have the best prices that I could find on cat back exhaust systems and the have Borla, Gibson, and a couple of others. Until the end of this month they have free shipping.