Search results

if any one is curious , i got a 01 xls for the wife, which is a little base model compared to my 97 xlt with leather... just has pw/pl/cruise anyhow, if you remove the bolts to the fuse box, and the 3 metal clips around it, and the dash surround around the cluster and the 2 bolts holding the...

thank-you for the replies, and its personal preference, i have busted a rear driveshaft before, removed the bolts out on the trails and drove 80 miles home in Front wheel drive, the slip yoke will drop the fluid out making that impossible if the rear shaft breaks. so for my short term goals in...

has anyone ever swapped one in a 1st or 2nd gen explorer? I know every one does the bw4406, which i perfer not to due to the slip yoke, but i was wondering about the bw4407? i have a 97 5.0 with a bad t-case(in 2wd now, using it for my Daily) and a 94 that is getting a 96 expo 5.0 drive-train...

the contacts need to be cleaned, where the 3 wires go to, it was sealed in my 2000 but i bet they are servicable like the guide shows:thumbsup:

just like to bump and say thankyou, i just did this to my 2000 ranger and it works better than new, all i did was take apart the electric motor and chuck the center part in a drill, then ran some fine sand paper around it until it was nice and clean, same with wear the brushes go, then i...

you could try to adapt a B2 tank but that may be alot of work just to level it out, but it would center the wieght. just an idea i guess.

eventually

Computer videos and Q/A , they are boring as h***, i work for wal-mart and unload thier stupid semi trucks 5 days a week. probally a new tech did the work, i duno, atleast you don't have to tell them to add 5-quarts when they add the oil(2.5l ranger, the computer think it is 4.5quarts :fire...