Search results

Good Evening All I'm starting my head gasket in the morning. Fel-pro gasket set, and new bolts. If there's anything I should watch out for, or tips to make it easier please let me know. I also have the wonderful luxury of air to tear her down. As always, Thanks everybody.

5 SPD, clutch pedal is very loose, seems that pressure is almost gone. Changed clutch/slave/throwout/pilot 2 years ago. noticed pressure decreasing two days ago, last night had to pump clutch to get it to dis-engage. Could the slave cyl. have been a POS and is going south already. As always, any...

My CEL is intermitantly coming on showing a code 41, (engine running lean) changed the TPS, O2 sensor, plugs & wires, and the MAF. When the light comes on and I give it alot of gas I get a small white cloud and my exhaust pipe is full of carbon. Any ideas????

As a few of you will recall, i'm the one with code 41 showing up intermitantly. The TPS and O2 Sensor are new, plugs and wires are new. I took off the plug for the MAF and just cleaned the plug off (no maf codes as of yet) I also had the Ignition pack ohmed out, primary and secondarys both...

Had a code 41, replaced the O2 sensor (the one in the "Y") cleared the codes. Ran good for about 20 minutes then CEL came on again with a 41 again. Why would this happen? A few people have said there's two O2 sensors on this thing but I can only find one. Any help/advice would be appreciated.

Can anybody tell me the trick as to which O2 sensor throws off a "code 41". Is it the sensor before, or after the catyletic converter. ??? Thanks.

My Exploder has me stumped once again, here we go.... First off, the heater core was replaced about 3 years ago and it's not leaking or anything so i'm thinking thats ok. I don't have any heat coming through to the pass. compartment at all, it's a tad bit warm but nowhere near it should be. All...

Hope somebody has an idea on this. Just returned from a 9 month boat ride to IRAQ. Wife wasn't driving my baby much so it was setting alot. Anyway, first my gas gauge was stuck on 1/4 so I filled it up hoping after a few days the float would un-stick. Not, the darn temp gauge quit too. Amps and...