Search results

Hi guys. Thanks for the response and links. It looks as if the blend door repair as suggested by thundertiger may be the answer to the problem. I will let you know once I have pulled the guts out. Thundertiger, I am particularly interested in yours as you have a right hand drive and you cured...

Heater Problem-Blend Door Hi Thundertiger, How do I search for "Blend door"? I am not to familiar with the web site. Thanks Henri

My brother's '97 Explorer seems to have jammed its heater and this stays on the whole time except when the a/c is set to "Max". We have pulled the dash out as far as posibble but cannot get to the heater control valve. This is operated by vacuum I assume from the temperature control on the dash...

Transfere Case Output Shaft Failure Thanks Robert, my sentiments exactly! My plans are the following: 1) Use this web site as proof (I have printed a few pages of discussions) and obviously your and hopefully more replies. 2) Ford South Africa has appointed Gearmax (where my vehicle was...

Hi guys My Explorer has had, to my mind, an unusual failure. The spline shaft which drives the rear prop shaft in the transfer case has excessive wear causing a "clunking" during up changes and sudden acceleration at speed. I took the vehicle to Transmission Specialists as I have breakdown...

O2 exhaust gas sensors Hi Guys. Sincere condolences for the tragic event. Finally got my problem sorted out by an American Car specialist, after the agents gave up. My vehicle is an Australian export model, and only has 2 exhaust O2 sensors before the cat convertor. The motor is 4L SOC. It...

Hi Robert, Thanks for the reply. Yes, the codes do read Ox sensors after the error codes of the Transmission are cleared. The local agent has 2 (my Explorer only has 2) on order, and I hope they are the correct ones, They should, as they have used the VIN number. The ones I have seen from...

Yes, thats them. One on each pipe just after the two "heat box" silencers. Do these fellas give any problems? If so, how often? As said, indicated by an orange warning light that looks like an engine. This eventually starts affecting the auto transmission by hunting 4th,5th under light load.

Thanks for the help with identification. Anyone experienced my problem? I would appreciate any help. I believe it could be the fuel quality causing this?

DPFE/ Oxygen sensors Hi out there. Seems some of you guys may be able to help. Are you discussion the sensors that bolt into the exhaust pipe just before the main silencer? My problem stems from the emission warning light (small orange engine) on the instrument binnacle coming on. Shortly...

Hi out there. Here in South Africa resources are limited and with our currency at an all time low, we look for the best deals! I have just fitted some Autolites copper core due to the Motocrafts being some 6 x more expensive! Could anybody help with the plug gap? I have set them according to...