Search results

Alright well I unplugged the sensor at the drivers side wheel, just a little goop. Cleaned it out and the problem is still there. But I left it unplugged, ABS light came on, but the issue is gone. So does this mean I need to replace the HUB for sure or is there something else it could be?

I don't even like ABS. I was always taught to brake by pumping the brakes on my own. Is there anything wrong with just pulling the ABS fuse and leaving it like that?

Yes, it is a 4x4. Which fuse do I pull to test if it is the ABS? Was that all you needed to do? Clean the rear sensor and it would have worked or should I order new bearings to replace? I've only had the car for about 2 years so I'm not sure if they're the original or not.

Brakes work fine for the most part, still have good amount of material left on the pads, no leaks (at least not that I can see). But every time I come to a stop, as soon as I get down to like 5mph, if feels and sounds like the ABS kicks in. It makes that noise and the pedal pulses. Brakes are...

I have a '99 Explorer XLT with about 130K miles. It only happens while I'm driving, but basically occasionally when I take my foot off the gas the RPM's drop like they should but sometimes keep dropping and I feel a dragging sensation on the vehicle. It then bounces back up and will sometimes...

I have a '99 Explorer XLT 6 cyl. SOHC. So my bank 2 is running to lean and my bank 1 has a "pending code" being too lean. According to my scan tool, my LTFT WAS about 10-15% (going up higher at idle) in both banks. Now, a couple days later, it's up to about 23% at idle in both banks and goes to...