Search results | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

Search results

  1. M

    2013 PIU Distance To Empty (DTE) Incorrect

    I guess bit-banging our vehicles might have caused the DTE calculation to be inaccurate. I also noticed my cars instant milage goes from 99mpg to zero. Nothing Inbeween. Average is running around 20mpg. So I would think the computer calculates the size of the take, remaining fuel, instant mpg...
  2. M

    replacing rear door speaker grills

    I picked up 2 door panels for a civilian explorer off of eBay. Panels are molded differently. You might get away with drilling holes but I thought it would look tacky. I picked up a OEM subwoofer for the right rear. Found the right rear quarterpanel at the local junk yard.
  3. M

    Vehicle image in IPC

    It was a generic pop up message.
  4. M

    Vehicle image in IPC

    Well, it was a try. The cables/connectors are in place behind the bumper but the sensors are missing. They are not cheep either! I thought BLIS was configured differently in the police version, more for officer safety then who's driving in the next lane over etc. My IPC has pop-ups for open door...
  5. M

    Vehicle image in IPC

    I believe it is part of the blind spot detection (BLIS) which is programmed to protect the officer if someone approaches the vehicle from the rear There are two sensors mounted behind the bumper , one on right side and the other on the left side. My PIU has the same icon however the sensors are...
  6. M

    License plate lights not working

    I was informed that the license plate lights were not working. I installed new bulbs, that didn't work. So I pulled the inside panels off of the tailgate and noticed the connector for the lights were disconnected. Plugged the connector in and the lights now work. Unfortunately I broke one of the...
  7. M

    Vehicle image in IPC

    My vehicle image does nothing. When I open a door, a pop up appears. Which module do I need look at to check settings?
  8. M

    auxillary audio input - wiring diagram on jack side

    Hello, Would like to verify that I installed the aux. Audio input correctly. Is there a wiring diagram for the harness? Would there be a photo of both connectors? I have the Ford manual, looks like 4 leads coming out of the ACM however 3leads go into the jack assy. Is this correct? My Mercury...
  9. M

    2014 PIU questions

    Changed plugs, misfire problem went away. Plugs were OEM factory plugs (yellow mark on tip)
  10. M

    2014 PIU questions

    KayGee, I have read a lot of complaints regard cylinder misfire problems. Boss at work has a F150 with cylinder #3 misfire. It's been to the dealer several times and they can't find the problem. You might be one of lucky ones that don't have the problem. The county sheriff department are...
  11. M

    2014 PIU questions

    I paid a little over $13k for my PIU. It had 104K on the odometer however, that doesn't include the time spent under a tree waiting for bad guys lol. Look at the engine idle hours on the display. I had roughly 5600 engine hours and 3400 engine idle hours. Actual mileage would be: true...
  12. M

    adding auxiliary audio input and remote start antenna part numbers

    I have a 2014 PIU and would like to add the auxiliary audio input jack to the stereo. Been searching for cable and the plate with Jack part numbers with no luck. Also have the remote start antenna but picked the wrong cable. The module is mounted on the dashboard just below the 12vdc...
  13. M

    Unknown Module and Antenna Connectors

    The 4 roof mounts in the middle might be antennas for LoJack Doppler tracking equipment. The mounts on the rear left and right may have been VHF/uhf/800mhz antennas The chrome cap in the front might be covering another mount for GPS? I bet the red wire is a 50 amp power point for radio power.
  14. M

    2011-2015 Police Utility Forscan Settings

    I just picked up a 2014 PIU. I managed to change a couple of settings using forscan, disabled dark mode etc. Was trying to compare the settings with your spreadsheet and have a question, The bit marked with a star would be the bit to change to enable options, correct? Is there a way to add the...
  15. M

    2008 Mountaineer Engine Compartment Distribution panel

    I figured out where the tow package is supposed to be if the vehicle was equipped. I will continue to investigate. Right now the fuse is cable tied to the box.
  16. M

    2008 Mountaineer Engine Compartment Distribution panel

    Hello, i o\have a question about the fuse/relay distribution box under the hood. there open sections that do not have fuse holders installed. looking at the box, the open space is on the fender side. i would like to know what would go in that spot and if so, is there a source to buy a fuse...
Back
Top