Search results

I'm trying to find out how many abs sensor fins are on the backside of the front brake rotors. Of course I could just jack up the front, pull the wheel, hub, spindle nuts, bearing, and rotor off, then just count them myself, and then put it all back together...but I was hoping that someone might...

A couple of days ago I replaced the factory radio in my wife's 94 Eddie Bauer with a new Alpine and retained the use of the factory JBL speakers, amps, and sub. The original setup still sounded great, so I figured there was no point in replacing anything besides the updated radio itself. I...

I have a Bronco II with a 4.0 and M5OD out of a 91 Explorer. Lately I've been experiencing a vibration that's dependent on engine speed. It starts at about 2000 RPM and goes away at about 2500. It doesn't matter what gear I'm in, but it only happens when the drivetrain is under load...

I just finished swapping an M5OD into my 94 Explorer in place of the A4LD that recently died. I kept the original EEC computer and installed the clutch 3-function switch to replace the original jumper and wired 33 ohm resistors in place of the shift solenoids. Now the engine isn't running very...

Missing sensor on 91 4.0 I'm in the middle of swapping a 4.0 from a 91 Explorer into a Bronco II. The Explorer originally had the heads off the engine when I acquired it and so there was a bunch of stuff not hooked up. On the harness that passes across the top of the firewall there's a pigtail...

I bought a 5-speed tranny from him. He gave me a good deal on shipping it to me in California from Illinois. The tranny arrived just as described. Good communication throughout the transaction.:thumbsup:

A couple of weeks ago I noticed our 94 Explorer started developing a miss. It was very subtle at first, most noticeable at idle. It's been getting worse and the power and torque just aren't there anymore. There's also a definite gasoline smell in the exhaust. According to the computer nothing's...

I have an 85 BII that I'm planning to swap a 4.0 into from a 91 Explorer. I also have an 86 BII that will be donating its fuel tank, lines, pump, and filter. I was just out looking at the fuel lines on the 86 and 91 trying to formulate a plan as to how I'll connect the 86 lines to the engine...

Yesterday I found a 92 Explorer at the junk yard with manual hubs. I've been wanting to convert my 94 from auto to manual hubs on the cheap, so I bought them. I was getting ready to remove the additional hardware and once I started picking off the mass of grease I was surprised to see that there...

I bought this Explorer not running about a month ago. Now that I've gotten the engine repaired, I've come to find out that the fuel gauge doesn't work. Stays at E, even when the tank is full. I've pulled out the cluster and cleaned up all the contacts, which fixed problems I had with a few...