mounting

Replaced my liftgate, and have it closing fine but I have this huge gap at the top. I’ve tried loosening the bolts and adjusting on the hinges, but it doesn’t seem to make a difference. Something I’m missing?

Hello, Finally managed to make progress on my 03 rear struts. New issue is the bottom mounting bolt is stuck. The tab snapped off while trying to remove the bolt and I am most likely going to resort to angle grinding through the mounting bolt to get it out. Does anyone know the part numbers...

Did my front brakes yesterday. It should have been a moment of relief, but after driving it maybe 50 feet, turning it off, and trying to start it again, I could hear the starter spinning, but no contact with the engine. I initially assumed my starter was bad. After getting a push start, then...

been thinking about adding led off lights to my 04 exsplorer but want to get some ides from what others had already done. The first spot i was thinking about was putting 2 3x3in spot lights inside the front grill and finding a way to snake the wires thru the fire wall. Let me know where youve...

I'm thinking of buying an LED light bar, however, I can't seem to think of where/how to mount it so I'd like it. The main concern is, I can't have it on my roof if it's higher than the roof rack. I park in a garage on a daily basis and this is what limits me from lifting the Ex higher...

A friend recently hooked me up with 2 pairs of Blazer International C9002K Baja lights. It comes with wires and they're even jacketed. I'm planning on mounting the lights themselves to the front of my gear basket on the roof of the Explorer. What I was wondering is where you guys have run...

The computer board in an oven was damaged due to the heat of a self cleaning cycle. The mounting tabs melted, so metal mending strips were used with self drilling screws to reattach the computer board.

Not my tire, or video, but worth the watch. http://www.liveleak.com/view?i=2f3_1309168599

This is the motor from a Craftsman cordless trim saw.

hey guys!!! been a while since i posted so thought i would do one now that i got my ranger done, i can now start on my front winch bumer. my idea is to measure out a peice of channel irn, cut heat and bend it on both sides (after measuring for winch mounting area) then welding to peices down...