shift motor

Alright guys… I’ve officially hit a mental wall. I am trying to fix the shift motor to get my 4x4 back up and running. I tried the test in the back with the 4 lights. That’s all good. Took the shift motor off and no surprise but the bushing in there was totally destroyed. So I replaced it with...

Hi, just wondering if anyone can give me some clues as to what my issue might be. The 4x4 shift motor does not seem to want to do anything when it is cold. I can hear the relays click when I press the button but it does not shift. Once the temp warms up a bit or the truck has been running for...

Ok, 4 wheel drive stopped working, i have push button inside and manual locking hubs outside. low range wont even come on although i can here the module working when i try to engage this. i have tried rolling the truck backwards in nuetral, and turning off the engine, its an automatic...

I have a 98 ford explorer XLT, it's stuck in 4wd auto with the dash selector on 2wd, and no 4wd light on the dash. so in neutral feet on brake selecting from 2wd to 4wd auto there is no click and cant hear it switch in the tranfer case but the 4wd auto light cames on. selecting from 4wd auto to...

My B4000 Mazda truck recently got stuck in 4WD low. After searching and reading a lot of threads in the forums, I was able to diagnose the problem as a bad shift motor, which seems to be a rather common problem. It wasn't fixable, so I had to replace it. The new shift motor comes with only...

Hello, I've been trying to troubleshoot my 4WD problems recently and have not been able to figure it out, despite my reading and rereading some threads that are related to my problem. So, I have automatic locking hubs on my 92, and the 4WD always worked like a champ in the past, typically I...

Looking for some input from the vast wealth of knowledge here on the forum. To give you a brief run down, I am swapping out my 4405 c-trac case for a 1354. The 1354 I have is an electric version and converting it to manual is a little pricey. This being said I am building a controller for the...

I have a manual 91 explorer xlt with bad u joints and ball joints, recently my 4wd got stuck in 4 low so i took the shift motor off and turned the pin to 2 hi but i cant turn the motor to the right position so that it can go back on. i cant use the 4wd due to the u joints and ball joints so i...

For some reason I keep blowing the fuse that supplies the backup lights, shift motor and O/D I think. I'm not sure why, I thought it was because of a messed up wire going to the shift motor. Today I fixed the wires on the shift motor, replaced the fuse, everything worked for a few minutes and...