93 x want mods please help

[rocklaurence]

Its a 93! Add a B/L trim the fenders and run 33's. I ran that set up with 33X9.5 on OEM rims for a long time. In reference to the motor mods, the T/B and exhaust were the best mods on mine. IMO, why run a 66 T/B into a 70 Mass? The motor sees the whole induction system at the smallest ID. Right?

 

[Bashman]

Kurt: the reason Jim and I could only run the 31's is with our setups we only have 1.5-2" of suspension lift while your setup would give you 3-4".

 

[AlaskanJack]

its weird cause I ran 31's with no lift. they were 10.5 wide and so I had no rub issues but the extra 1" caused slight rubbing on front valance at full lock.

 

[ld50]

Same here, I had 31s on before any lift, only a tiny bit of rubbing when stuffed and turning, and that was just on the tupperware and a bit on the inner fender liner. No rubbing after the spacer lift, then of course the body lift made the tires look too small so I had to go 33. I could not have fit the 33 without trimming, it`s possible 32`s may have fit though? It would have been tight.

Kurt: the reason Jim and I could only run the 31's is with our setups we only have 1.5-2" of suspension lift

It was interesting that my poly spacers were actually 2 inches while the f-150 spacers are less than that, I noticed this when doing them on Carsonm`s truck. So I have more suspension lift than him, therefore my Ex is 10 times better!


OH YEAH don`t forget the caster adjustment needs to be done if you use spacers! this means you need to hit the alignment shop after.