russosborne
Active Member
- Joined
- August 29, 2011
- Messages
- 93
- Reaction score
- 1
- City, State
- Glendale AZ
- Year, Model & Trim Level
- 2010 Subaru Forester
I read a great post here about using a piece of all thread and a cabinet pull. I will likely do that on my 97.
But while looking at the rod where the handle went I noticed that it seems to be threaded. Am I imagining that? I didn't get a good look, lousy eyes, but it felt threaded, and bigger diameter than the all thread.
If it is, does anyone know what thread size it is? Seems it would be nicer to get a handle of some sort and just drill and tap it to fit the original rod. Less stuff to break that way.
Thanks,
Russ
But while looking at the rod where the handle went I noticed that it seems to be threaded. Am I imagining that? I didn't get a good look, lousy eyes, but it felt threaded, and bigger diameter than the all thread.
If it is, does anyone know what thread size it is? Seems it would be nicer to get a handle of some sort and just drill and tap it to fit the original rod. Less stuff to break that way.
Thanks,
Russ
