jpanderson0318
New Member
- Joined
- February 17, 2008
- Messages
- 7
- Reaction score
- 0
- City, State
- Camp LeJeune, NC
- Year, Model & Trim Level
- '00 Ranger XLT
I did a VIN lookup, but there is not information about whether I run OHV or SOHC. I have a 2000 Ford Ranger with a V6 3.0L Flex Fuel.
Also, I recently replaced my rear main seal, flex plate, torque converter, oil pan gasket, and did a seal job on my trans. Since then my engine started clicking. It sounds louder from the underside of the vehicle. Reading around I saw that the oil lifters are a common source of that. I am hoping I have an OHV engine and that the lifters are the source of the problem.
[EDIT]
Also, I switched from regular oil to synthetic oil, which I read can precede the engine clicking.
Also, I recently replaced my rear main seal, flex plate, torque converter, oil pan gasket, and did a seal job on my trans. Since then my engine started clicking. It sounds louder from the underside of the vehicle. Reading around I saw that the oil lifters are a common source of that. I am hoping I have an OHV engine and that the lifters are the source of the problem.
[EDIT]
Also, I switched from regular oil to synthetic oil, which I read can precede the engine clicking.
