Dynamat and subwoofer

[aldive]

I am going to install an MTX Amplified ThunderForm in my 88 very soon. I am wondering about rattling and vibrations; I have been advised to use Dynamat in the install.

My question is exactly how do you use Dynamat and where do you put it.

Any help appreciated.

Thanks…

 

[nosaj122081]

To install the Dynamat brand deadener you gotta use a heat gun and press it to the surface, I use a roller I bought along time ago to get air bubbles out... If you're just going with the MTX Thunderform, I'd put some deadener behind the enclosure on the inner 1/4 panel, and probably on the back of the plastic interior 1/4 panel...

FYI: If you don't have a heat gun, or don't want to go to the trouble of farting around with one, go with Cascade brand V-block stuff... www.partsexpress.com sells the Cascade stuff. I personally like the Cascade products better than the Dynamat, I've installed both and prefer the ease of install of the Cascade gear, and I like both better than spray on stuff, its easier to reverse... HOWEVER, I usually use Ice-Guard (or Ice-Block, something like that). Its the same thing, an asphalt based deadener, but it is used on roofs under the shingles. You gotta buy it in huge rolls but I sell off what I don't use or go in with some other guys on a roll, and its EXPONENTIALLY cheaper. Good luck!