DitchWitch
Active Member
- Joined
- September 11, 2007
- Messages
- 54
- Reaction score
- 3
Well first of all thanks for taking the time to read this and possibly help me.
95 4.0L 4wd
Story goes: Tranny went out one day. Didnt have $1600 for cottman. Paid a local guy $700 to rebuild it. Got it back and the O/D light is still flashing. When the light is off it runs and drives perfectly, way better than I have ever felt in it.
I go to a local shop to get codes: word for word..ready
652 Modulated Lockup solenoid CKT (?)
157 MAF signal too low
176 EGO not switching(?)
214 Cyl ID CKT Fault (?)
327 EGR signal
628 Excessive coverter clutch slippage
646 Incorrect 2nd ratio
647 Incorrect 3rd ratio
648 Incorrect 4th ratio
To make a long story short. After visually inspecting everything..it looks like the whole wire harness block on the side of the tranny is toast. All the wires are completely bare. I am hoping someone has a diagram for the whole block of wires...praying if I rewire it..the o/d light will stop... or is this something I should just get from the junkyard?
Also, he told me something about the computer is not the updated one? Anyone know about this!?
Lastly..the MAF issue. When I got this truck it came witha PVC 3" intake..and I think its throwing it off. What is the stock diameter?
If your still reading this...thanks :exp:
95 4.0L 4wd
Story goes: Tranny went out one day. Didnt have $1600 for cottman. Paid a local guy $700 to rebuild it. Got it back and the O/D light is still flashing. When the light is off it runs and drives perfectly, way better than I have ever felt in it.
I go to a local shop to get codes: word for word..ready
652 Modulated Lockup solenoid CKT (?)
157 MAF signal too low
176 EGO not switching(?)
214 Cyl ID CKT Fault (?)
327 EGR signal
628 Excessive coverter clutch slippage
646 Incorrect 2nd ratio
647 Incorrect 3rd ratio
648 Incorrect 4th ratio
To make a long story short. After visually inspecting everything..it looks like the whole wire harness block on the side of the tranny is toast. All the wires are completely bare. I am hoping someone has a diagram for the whole block of wires...praying if I rewire it..the o/d light will stop... or is this something I should just get from the junkyard?
Also, he told me something about the computer is not the updated one? Anyone know about this!?
Lastly..the MAF issue. When I got this truck it came witha PVC 3" intake..and I think its throwing it off. What is the stock diameter?
If your still reading this...thanks :exp:
