fireballkiller
New Member
- Joined
- June 4, 2010
- Messages
- 7
- Reaction score
- 0
- City, State
- Tiller, OR
- Year, Model & Trim Level
- 96 Explorer XL
Hi..Im stumped. I have replaced the IAC (been acting up for some time). Adjusted TPS to correct voltage, and performed WOT test(cleared it up a little). And cleaned MAF. Cleaned all connections. Cleaned all Relay connections, Cleaned out Fuel filter, have not check FPR, checked fuel pressure (30 PSI running, 10 PSI key on position) Here's the problem: I replaced plugs with Iridium Plugs and new wires, also did an oil change. Vehicle ran AMAZING for about 2 weeks. Than suddenly out of nowhere the CEL comes on. It either is a VERY hard start when warm, after driving, or somewhat hard start when warm.Once it starts it runs BEAUTIFUL, idles great, throttle response amazing, gas mileage whats expected. CEL still on. Here's the interesting part, while driving down the road the CEL will suddenly go off, however, it will not shift gears at 55MPH, and im running 2500RPM's at 55MPH. Then the light will come back on and it will finally shift, then im running 1800RPM's at 55MPH..I cant afford to have codes run because I spent all my stupid money on the IAC motor (124.00).PLEASE HELP! I'm taking a 2000 mile trip soon, and I really want it running without the stupid hard start (Its really not good for the starter, which by the way is also brand new, and so is the battery)..hope that wasnt to confusing...thank you..