Help!! Need torque values

[Keith in Mich]

Putting fly wheel in after work misplaced book, need torques for the fly wheel, bell housing, drive shaft reart and front,

thanks keith

 

[Keith in Mich]

Sorry it is a 1992 ford explorer

Soory on lunch in a hurry car in question a 1992 ford explorer.

 

[Lloyd10977]

Soory on lunch in a hurry car in question a 1992 ford explorer.

That's all good, but you forgot to include 2 wheel or 4x4? Manual or auto? 4.0l OHV? But I'll try to help. All values are pound-feet unless otherwise stated, from the Haynes repair manual:
flywheel/driveplate bolts, step 1= 108-132 in-lbs
flywheel/driveplate bolts, step 2= 50-55
transmission to clutch housing= 18-38
mount to crossmember nut= 65-85
crossmember to frame nut and bolt= 65-85
automatic transmission to engine bolts= 28-38
torque conv to driveplate nuts= 20-34
neutral start switch= 84-120 in-lbs
clutch pressure plate to flywheel bolts= 17-23
release cylinder to clutch housing bolts= 13-19
drive shaft to xfer case bolts (4WD)= 12-16
driveshaft to rear axle with double cardan U-joint=70-95
driveshaft to rear axle with single cardan U-joint= 8-15
driveshaft to xfer case flange bolts= 70-95
driveshaft to differential yoke bolts= 120-180 in-lbs

 

[jumpn4jesus]

That's all good, but you forgot to include 2 wheel or 4x4? Manual or auto? 4.0l OHV? But I'll try to help. All values are pound-feet unless otherwise stated, from the Haynes repair manual:
flywheel/driveplate bolts, step 1= 108-132 in-lbs
flywheel/driveplate bolts, step 2= 50-55
transmission to clutch housing= 18-38
mount to crossmember nut= 65-85
crossmember to frame nut and bolt= 65-85
automatic transmission to engine bolts= 28-38
torque conv to driveplate nuts= 20-34
neutral start switch= 84-120 in-lbs
clutch pressure plate to flywheel bolts= 17-23
release cylinder to clutch housing bolts= 13-19
drive shaft to xfer case bolts (4WD)= 12-16
driveshaft to rear axle with double cardan U-joint=70-95
driveshaft to rear axle with single cardan U-joint= 8-15
driveshaft to xfer case flange bolts= 70-95
driveshaft to differential yoke bolts= 120-180 in-lbs

Make SURE to read CAREFULLY these specifications!
Me and my ex-mechanic buddy were putting my flywheel back on and thought it said 108-132 ft-lbs. Doubted it but, its the manual right!
Well, needless to say, I sheared of a bolt. Thankfully it came out, but now I can't find any friggin place that sells flywheel bolts! Even called 2(two) Ford dealers and only one said they could get them. So that would be another 2+days! We stressed at least 2 other bolts, so just going to replace them all!

READ 2 times!

Sorry to bring this thread back from the dead!