Help with locker and c-clip removal.

[Tyler2616]

I have a 95 ranger lifted with 5.0 4speed and np205 to rock crawl with and I'm trying remove the rear axles. But it has a locker in it and I can't get the thing out. Removed cross pin all springs and alignment pins. But no luck, anyone have pics video some kind tutorial how get it out? I believe it's a Aussie or a spartan. I'm going back together with c clip eliminators a and longer wheel studs, aby help be appreciated.

 

[RangerX]

Welcome Tyler!
I moved your thread into the Ranger section.

What's the rear axle? If it's stock, it could be 8.8 or 7.5. With your swapped in drivetrain, it could be anything from a 9" to 10.25 to D60.
That info will help get you answers.

 

[Tyler2616]

It's a 8.8 in it. I finally got it out. Took all springs and alignment pins out and spread the cam gear apRt on passenger side and took magnet and pulled c clips out. But def need better way!! Thanks.

 

[RangerX]

Good to hear.

Care to share any more specs on your Ranger? Or pics?

 

[Tyler2616]

I'm not sure how post pics on here off my phone. Never really been on forums, it says post URL of image...

 

[jd4242]

You took the calipers off and pushed the axles in right? I then turn the axles to where the clip will fall downwards. Little jiggle and tap, it should fall straight down

 

[Tyler2616]

Got drum brakes on rear had them all way in jiggled and pulled and pried but no luck I got them out between the inner and outter cam gear