need more height

[hawaiianexp00]

Ok i have the AAL and TT but the left Tortion Bar can only go maybe one more turn what else can i do cause i want to put shakels on also

 

[section525]

How many inches did you get out of the TT?

 

[hawaiianexp00]

well i measured the rear before and after from the tire to the center of the wheel well and after i came out with 2 1/8 but i did not do the front, i just went with 4 turns of the Tortion bar I would have done more up front but like i said the left side is almost maxed out

 

[Digger196]

let them both back out and try again and first measure from the ground to the wheelwell when ya start and then twist it the one side then let the X down and see how much it went up. then repeat for the other side till ya get about the same as the back.

the thread on the T bar might be stuck so lub it up with WD-40 the night before ya do this. good luck.

 

[hawaiianexp00]

when i first started twisting the Tortion bars they were already uneven, the guy that helped me said they came like that from the factory