- Joined
- August 26, 2004
- Messages
- 2,961
- Reaction score
- 132
- City, State
- West Virginia
- Year, Model & Trim Level
- 1993 2dr
I was looking over the top of the engine today and noticed some spots on the dr side valve cover where oil had dripped. I take a look at the vacuum tree and notice that the rubber connectors on the 2 small plastic hoses were swollen, i take them off and there is noticeable wetness from oil in the vacuum tree. I know from searching that one of the plastic lines runs to the filter box and the other to the FPR. I plan on capping the one going to the filter box seeing as the box isnt even in the truck anymore.
Obviously oil getting into the FPR isnt a good thing so I need to try and find whats causing the oil in the intake. It does seem like oil and not tranny fluid so that rules out the trans modulator valve. The pcv valve is new and i did not notice any wetness in the hose from the valve to the intake. The intake gaskets are new, as well as the valve cover gaskets. I know that some oil is normal but this seems a bit excessive. Any help or guidance you guys can offer would be greatly appreciated.
Obviously oil getting into the FPR isnt a good thing so I need to try and find whats causing the oil in the intake. It does seem like oil and not tranny fluid so that rules out the trans modulator valve. The pcv valve is new and i did not notice any wetness in the hose from the valve to the intake. The intake gaskets are new, as well as the valve cover gaskets. I know that some oil is normal but this seems a bit excessive. Any help or guidance you guys can offer would be greatly appreciated.