PLEASE help me

[bbmoose]

I already posted here that i was having headlight problems.
Well i got the headlight stook and installed it.
Well i had lights but the wipers would stay on high no matter what i tried.So i got the new harness and VERY CAREFULLY wired it in 1 wire at a time.
Still the same problem?
Reconnected the old and no headlights but wipers didnt stay on(they worked like they should normally).
Well after 2 hrs i got the wipers to work correctly with the new stick but now i have high beams on all the time,the rubbing lights work normally but you cant get headlights to work without the key on,if you start the vehicle the highs come right on BUT i cant select low beams?

I checked all the fuses(under the hood and drivers door), could a relay be bad now?

If not any ideas.
PLEASE HELP

 

[bbmoose]

ok i just played around even more.

Now somehow i must have messed up the wiring( i honestly thought i was being careful doing it).
Now i have highbeams when i start the vehicle and if i press the lever like to flash to pass the highs go off and there is low beams on then and i have the highbeam light indicator on the dash goes on(like if you hit the highbeams normally).

Do i think i rewired it wrong BUT i dont know which wire goes to the lows and the highs.

Please help me out here.

thanks alot.

 

[bbmoose]

also which terminal connector of the 2 that plug into the stalk is the lights?
The smaller square on is the one i rewired,so i guess thats the one.
Please if you know let me know.

 

[bbmoose]

someone hopefully will help.
Please

 

[zensius]

I don't know anything specific about this but it seems all you have to do no is reverse the wires going to the headlights. Because you lows come on when the highs are supposed to and visa-versa. Good luck.