cold beer
New Member
- Joined
- September 16, 2009
- Messages
- 4
- Reaction score
- 0
- City, State
- Simpsonville,SC
- Year, Model & Trim Level
- 2013 Explorer XLT
This is my first post and it is to thank everyone who shared their info and experiences repairing their explorer.
I have repaired the keypad, (broken wires at door hing) odometer readout,
(cold solder joints) dtc p0402, (bad egr position sensor) all in the past few days
and saved a ton of money. My next job is to take care of that roar in the rear end ! I just need to get the lub.(found that here too!)
Sorry I didn't post when I signed up but I learn from reading and not from posting so I have been reading a lot.
So now it's time to post and to again thank everyone for sharing.
Daniel (cold beer)
I have repaired the keypad, (broken wires at door hing) odometer readout,
(cold solder joints) dtc p0402, (bad egr position sensor) all in the past few days
and saved a ton of money. My next job is to take care of that roar in the rear end ! I just need to get the lub.(found that here too!)
Sorry I didn't post when I signed up but I learn from reading and not from posting so I have been reading a lot.
So now it's time to post and to again thank everyone for sharing.
Daniel (cold beer)
