So much for the life of my MT's

[joker1457]

Take a look at the ones on the truck now. If they are brass colored they are the superlift ones, and there is no point in tearing everything apart. Superlift, at least mine, had a degree stamp on them that is pretty visible. It'd be worth checking out

Thanks Jim, did'nt know you had the super lift on your mounty but I will definatly check. Hopefully your right!!!!

 

[V8BoatBuilder]

:thumbdwn:
Did you put them on? I just purchased the same set....

Putting them on this weekend if I have time.....

No, I was all set too put them on; I removed the old ones, lined the two sets up for comparison, scowled, frowned, dropped the eff bomb..... and then put the old ones back on.

 

[ivrb]

cambolts

what did you find

 

[joker1457]

http://www.shopequipmentparts.com/s...age=product_info&products_id=444&currency=USD
They look like this. You need one kit per side--or 4 of these all together.

This is a 3.25 degree kit. You may have to enlarge the slide hole a bit on the frame to get full adjustment. Make the oval hole about 1/8" larger to outboard.

Well thanks to everyones help, two sets of tires, many headaches, and a few $$$. My Ex is finally in alignment. I used the above cam bolts, my vehicle is lifted with superlifts 4" lift and aparently the aftermarket cam bolts where not put in when the lift was installed.

Thanks for everyones help!

 

[GRNMACHINE]

Glad to hear it, are those MOOG cam bolts? Purchased the MOOG brand and not sure what the degrees are. Wont be putting them on until the summer along with Upper Control Arms and Tie Rod Ends.