wanna keep all my space but still have king kong in the trunk

[bsquared25]

i love all the space i have in the back end but im always hauling ****. but at the same time i wanna try and put some sorta subs whether its only one or 2 10's with takin up as little space as possible. if yall have anyway creative way yall set yours up post it, bc i have completley blank on how to pull this off thanks yall

 

[Triton8273]

Put them where the stock sub is.

They make ones that are direct fits in the back but cost around $600

 

[Kazer]

Do search for a member named "-strike-". He has one 12 built into the floor in the cargo area. It's all custom but looks very clean

 

[stuartr]

Look in the 3rd gen pics "I know 198 pages!" there is a guy that has a wicked tricked out X that has an encloser that goes on the side where the factory sub goes in his. I would have to have one. I can't remember his screen name. He has custom made fender flares, a custom roof rack and all kinds of nice stuff.
Stu

 

[Kazer]

Hey stu, are you thinking about PWRaddict's explorer in the 4th gen pics thread?

And bsquared, you could do a 10" jl audio stealth box, but they're like $600 (edit: I think this is what triton was referring to)

 

[Teejay4490]

King kong with two 10's?

Get a 24 inch solo baric

But really though get a box with two 12's.

 

[Bruces expo]

I Have 2 10"s That are very loud , there Critical mass Reference ss102 there single 2 ohm , so when wired to a mono amp its 1 ohm and there made for high excursion and small enclosures ! do some research on small sealed or small ported enclosures and figure what you want for space , but also have a sub back there , i like CM there amazing subs , but are pricey because of there Quality

 

[Kazer]

Sure it's also in the Audio forum;

All KnuKoncepts wiring 1/0 Power/ground, Knu battery terminals 4 Gauge to the amps, power distrib. block, ground dist block, 12 gauge speaker wire. 2 and 4 Channel RCA's, And big 3 upgrade.

Pioneer AVH-P4300DVD
Pioneer GM-D8500M 1200W Mono Amplifier
Pioneer TS-SW3001S2 2Ohm 1500w 12" Shallow Mount woofer
Infinity Kappa 682.9CF Component door speakers

Old School Amps for the components, I want to get a Kappa Four;

Rockford Fosgate 120.2 for the front door speakers
Rockford Fosgate 201S 600w max - 100w RMS x 2 @ 2 Ohm for the Rear door speakers

 

[kp02-150]

I'm kind of in the same boat with my aviator. I've got two 12"s in my f150 under the back seat that I love. I want something that's totally stealth, but think I'd like to go with some low profile 15"s and use the whole back compartment. I'd like to end up with something that I could still stick stuff on top of.

I did find a nice setup someone had that was actually hinged and covered the whole cargo area, but I can't seem to find the thread now. I figure the amps can go underneath the trim panels on the side where the factory amp(s) and sub are.

 

[HiImBrian]

I was thinking about using this setup from my dad's studio...

 

[kp02-150]

I used to drool over carvin catalogs all the time. Tried to put together one of their custom guitars multiple times, but they always came out around $1500+ by the time I was finished adding everything.

 

[HiImBrian]

I used to drool over carvin catalogs all the time. Tried to put together one of their custom guitars multiple times, but they always came out around $1500+ by the time I was finished adding everything.

I'm a bass player and I spend a generous amount of time there. He had to lease the rest of the building because the bottom end would rattle shelves in the other rooms...

For those keeping score, that is 8 subs, 1000 continuous watts each =]

I have 2 Carvin basses and my dad has a few guitars. I love them....