screw

I opened the S/C bleeder screw and did not get any fluid flow, just the occasional small bubble. I removed the bleeder screw thinking it might be clogged. Found this clumpy white stuff clogging it up, and slowly coming out of bleeder screw port. I finally got fluid flow and went to put bleeder...

I am working on my 2005 Ford Explorer XLT to change the fuel pressure and temperature sensor which is under the upper half of the intake manifold. Based on what I have discovered, there are 8 total T30 Torx head bolts securing the upper half of the intake manifold. I managed to get off 6 of...

So I was pulling some wires behind the A/C console, which means the A/C manual controller plate (see here) had to come off, and one of the 4 hex-screws unluckily fell somewhere deep within the car... frustrating, as I'm always real careful. Hoping to find it one rainy day, perhaps. Anyway, I...

I decided to restore my roof rack, this morning I removed the rear roof rack with ease,the front was a different story, a passenger side screw isn't coming off. It just turns, and appears to be damaged in some way. I would like to avoid painting the rack while on the vehicle if at all possible...

I feel like a complete idiot right now, but what holds the rear coat hook on? I know it's a screw, but can someone tell me what kind? I've tried everything from a 5mm - 7mm, and imperial sizes as well, nothing works on this little screw. I can't get my rear quarter panel back on properly...

The part number from Motormite/Dorman/Help is 47392. The size is 7/32".

Hey all! I've been looking every where online since last week for a specific type of ford screw. It is the flatish round screw that attached the window of the liftgate to the liftgate window hinge. My subs backed out the screw while cruisin and it fell out the car. So i looked everywhere...