Hixc
New Member
- Joined
- January 18, 2020
- Messages
- 1
- Reaction score
- 0
- City, State
- Ashtabula, Ohio
- Year, Model & Trim Level
- 2004 Mercury Mountaineer
I have a 2004 Mercury Mountaineer 4.6L V8. I have a code for P0354 that comes up for ignition coil D. I have a multimeter and have tested the COP Harness connector and do not get a 12v signal. However i get a 12V signal on the other 7 Plugs. I have also tested for continuity between pin E35 on the PCM side to the COP Harness and checks out good. I have also checked for resistance and get a reading of 0 ohms. So i jumped a wire from the battery to get a 12v Signal to the COP harness and was able to get the plug to fire and pulse. However when i do that, my check engine light flashes and gives me a whole new mess of codes.
P2110
P0122
P0223
P0403
P0406
P2100
P2106
P2107
B1600
B1681
When i unplug the COP, these seem to go away. however now i have codes for
P0354
P0316
P0302
I have replaced every sparkplug and every single ignition coil 2wice.
P2110
P0122
P0223
P0403
P0406
P2100
P2106
P2107
B1600
B1681
When i unplug the COP, these seem to go away. however now i have codes for
P0354
P0316
P0302
I have replaced every sparkplug and every single ignition coil 2wice.