dfox52
Active Member
- Joined
- September 12, 2015
- Messages
- 50
- Reaction score
- 18
- Year, Model & Trim Level
- 2013 Explorer XLT
I'm replacing the rear wheel speed sensors on my 2013 Explorer and I have a slight problem. The other end of the existing connector harness is up over the frame in a tight spot where I can only fit two fingers to work with. I was hoping someone could give me a quick overview on how this harness connects/disconnects so I can try and disconnect it with just two fingures without having to figure out how it comes apart at the same time. Thanks in advance!