Search results

ex for sale Iam in Elida ohio

new problem well got engine back together . Ran fine . no leaks . ran it around for about 45 min . no leaks . did not over heat . Brought the Ex back to the house . shut it off to move other truck .and now the Ex wont start . It will turn over but wont start . Its getting gas . Got good fuel...

thank you natenkiki2004 . I will try this .

at $59_$97 . I dont know .I just want to get this fixed and Im selling It . This Ex has been a $$$$$ pit . Its in mint shape . Cant keep throwing $$$ in it .

lower intake reinsall thats it ? I dont have to go around the water jacket ? The intake gasket i have is one piece.

I have a 94 ex with a 4.0 . I found I had a head gasket leaking . I have replaced the head gaskets an reinstalled the heads . Does sealant have to go around the water jacket and across the front an back of the block or just across the front an back of the block ??? Does any one know of a video...

crank wont start yes That is the crank sensor . check the wires , check the alignment . My wires were loose . Check the ignition modul . this also went bad on me . When did you replace the fuel filter.

coolent loss well found my problem , Pulled the heads and found back cylinder on drivers side was leaking in cylinder . Every thing looks ok . Cleaned block and heads . put heads back on . The lower intake does sealer have to go around rear/front water jacket an front /rear of block on both...

hello guys . Sorry I ve been away for a while . my job and new house have been keeping me pretty busy . I have two problem I was wondering if some one could help me with . fist one is with my cooling system . The antifreeze keeps disappearing .???????? . drained the oil , none in the oil .Its...

well found problem with ex .Broken ignition wire from ignition switch to starter solenoid. Ran new wire and ex starts with key. Oh I am so glad this is fixed . I hate wire problems. Iam looking for the air tube that runs from the maf sensor to the upper in take . any one have a good one laying...

ex wont start well I changed the ignition switch .(not the key ignition ) and it still will not do any thing .%$#@&^ . Oh this is so mind boggling . I am tracing the red/blue wire off the starter solenoid . the wire diagram shows this wire comes from the ignition switch to a "clutch triple...

ex wont start just checked all fuses, all are good .

%$#@&^* Hi guys . Well still playing with ex . Still nothing . I'm thinking of replacing the ignition switch . But where the %$#@^% is it ? chilton and other repair manuals says it on the steering column ,but all i see is the multi function switch with a bunch of wires going in to it . Where...

Hi guys . Well still no start with ex . pulled wire harness from transmission and inner drivers fender . did continuity test found two broken wires.spliced new wire in and redid continuity test and all wires read good . put harness back on truck and still nothing . took neutral safety switch...

ex wont start Well it wasn't the starter solenoid. Still when you turn the key there is nothing. If I tun the key on and jump the start wire and battery wire on the solenoid the ex will start . the lock part on the ignition spins , It was this way when I bought it from this wanna be mechanic...

94 ex wont start thanks for the help guys , but it dont want to do nothing ,no clicking . the dash lights come on ,the door chimes . But nothing else . Had the starter checked , They said it was good .Im going to change the starter solenoid to see if this is the problem . Jumped it with a piece...

Hi everybody , sorry for not posting for a while . Just bought a new house . been busy . I have a 94 explorer limited .4.0 auto . left the house the other day truck started fine . to the store came out and the ex wont do nothing . All lights work . But you turn the key and nothing .I have...

94 explorer 5.5 lift Morning guys . crispy but sunny here in Lima ohio. (26 degrees) Here is the lift kit I am going to order http://www.superlift.com/lift-kits/5.5-1990-1994-ford-mazda-explorer-navajo-superunner-suspension-lift-kit.asp I need $ 25000 to order it . Will keep you all up...

94 limited transmission wire harness Looking for a 1st gen transmission wiring harness For a 4.0 auto trsns It has two sets of wires. I need it from the drivers inner fender to the trans . ( no burnt wires - this is whats wrong with mine) I have a ex limited dont know if this matters

thanks maniak, This is a big help . I am looking in to buying the lift kit this year , maybe in the fall and make it my winter project next winter . I will buy this axle under kit too . Thanks again joey

Looking for a 1st gen transmission wiring harness For a 4.0 auto trsns It has two wires. I need it from the drivers inner fender to the trans . ( no burnt wires - this is whats wrong with mine)

rear seal replacement are they putting indian head sealer on the engine side of the seal ? you cant just put the seal in . I had this problem . When I pulled the old one out there was no sealer on it . Thi could be your problem or wrong seal

fly wheel still doing good Hello every one .Hope you all had a nice xmas and a happy new year. Well the ex is still running good . Dont know why I kept breaking fly wheels . The bone yard one is still doing good (knock on wood ). We are suppose to get snow/freezing rain this week end so might...

I have a 94 explorer limited that I would like to do a 5.5 ' lift on . I was told that I would have to flip my rear axle and use blocks to lift the rear . Is this possible ? I am looking at the super lift suspension lift kit . Does this kit come with everything to do the lift ???Thanks to...

Fly wheel/flex plate keeps breaking Hello every one . Sorry for taking so long getting back on here . work ,work ,work ,It seems like that,s all I do any more .:) Got to keep the bills paid . Any way ,I took the fly wheel back and went to the bone yard and got one from a 94 4.0 engine .The...